Turcee T-Car Weather Stripping Seal 5M (16.4ft) | Reduces Wind Noise & Dust Ingress

• Upgrade T-Car Weather Strip: Don't put up with the large gap between the front windshield and sunroof causing leakage into dust and the terrible wind noise on the highway! The upgraded T-seal strip can perfectly fill the gap between the front windshield,rear windshield, sunroof and frame
• Easy to Install: Thoroughly clean the installation surface; keep the installation environment temperature between 50°F - 85°F. In case of low temperatures, preheat the sealing strip indoors in advance; to ensure waterproofness, cut the end of the sealing strip at a 45° angle for a tight joint; use the attached adhesive-promoting wet wipes (check the humidity before use) to wipe the installation surface, and press firmly for 30 seconds after installation
• Wide Range of Protection: 14mm*5M T-edge seal strip can be cut upon need for any car small sunroof(3M),panoramic sunroof(7M),both sides of windshield(2M),both sides of rear windshield(2M),etc. Note: The sunroof cannot be opened again after the rubber sealing strip is installed
• Installation Note: The effective temperature range for the product to maintain its adhesiveness is 50°F - 85°F. Avoid using it in extremely high or low temperatures (below 45°F). If it is necessary to use it in extreme temperatures, it is recommended to use it with 3M sealing strip adhesive
• Notes: The thickness of this product is only 3mm/0.12inch, which is relatively thin and not easy to bulge. The width is 14mm, which is narrower compared to other sizes. It is recommended that you measure the gap you need to fill before purchasing to avoid incompatibility issues

• Prepare the Surface — Thoroughly clean the installation area on your car's windshield, sunroof, or tailgate. Ensure the surface is dry and free from dust or grease for optimal adhesion. Ideal application temperature is between 10°C - 30°C.
• Apply Adhesive Promoter — Use the provided adhesive-promoting wet wipe to clean the installation surface again. This step is crucial for ensuring the powerful adhesive bonds effectively and lasts longer, especially in varying Indian weather conditions.
• Install and Press Seal — Cut the T-type seal strip to the required length, using a 45° angle for joints if needed. Peel off the backing and carefully apply the strip to the gap. Press firmly along the entire length for at least 30 seconds to secure it.

Typical situations where Turcee T-Car Weather Stripping Seal 5M (16.4ft) | Reduces Wind Noise & Dust Ingress helps — illustrative scenarios, not customer reviews.