CloudBuyer L-Shape Car Weather Stripping 20m (66ft) | Noise Insulation & Draft Seal

• Safe And Durable: L shape design,non-toxic,more durable and flexible.Noise Reduction, Waterproof, Dustproof & Soundproof & Windproof.High temperature resistance & cold resistance, prevent ultraviolet light.one roll specification:13mm (47/100 In)width x 10mm(2/5 In)height,length 20m(66Ft).
• Effect Upgrade: The L type is upgraded on the basis of the B type. The L-shaped design makes the fit better, and the three-pipe design makes the sound insulation and sealing better. The increased thickness makes it compatible with more car models. Effect UpgradeThe L type is upgraded on the basis of the B type. The L-shaped design makes the fit better, and the three-pipe design makes the sound insulation and sealing better. The increased thickness makes it compatible with more car models.
• Air-tight: This weatherstripping enhances the leakproofness of your car, which make door close more tightly .Reduce the noise of wind when you drive your car at high speed. Have a nice trip with your family.Make your car more sealed so that you could keep your car away from dust, raindrop and Fog. Soundproofing insulation best waterproof dealer.
• Easy Installation: Easy-installed tool.Direct replacement tape, you just need to push the stripping foam on the rubber sealant above the installed place.
• High Quality Weatherstripping: It will seal the gap between car door, car body, car hood, bed rail etc. Enhance driving comfort while cruising on the highway. Excellent sound proof compression set resistance for maximum service life and vibration absorption.

• Prepare the Surface — Clean the area where the seal will be applied thoroughly with soap and water or an automotive cleaner. Ensure the surface is completely dry and free from dust, oil, or wax for optimal adhesion.
• Apply the Seal — Peel back a small section of the adhesive backing from the end of the weather strip. Align the L-shape profile with the edge of the car door, hood, or window, and press firmly into place.
• Continue Application — Gradually peel off the remaining adhesive backing while pressing the weather strip firmly along the entire length of the application area. Ensure a continuous, even seal without stretching the material.
• Trim and Secure — Once applied, trim any excess length with sharp scissors or a utility knife. Press down firmly along the entire length one last time to ensure maximum adhesion and a secure fit.

Typical situations where CloudBuyer L-Shape Car Weather Stripping 20m (66ft) | Noise Insulation & Draft Seal helps — illustrative scenarios, not customer reviews.