MG Chemicals 841AR-P Nickel Conductive Pen 5ml (0.17 Fl Oz) | Fast Drying Circuit Repair Pen

• Creates durable, reliable, highly conductive connections
• Low volume resistivity: 0.0068 ohms·cm
• Typical trace width: 1.0 mm
• Dries to touch in minutes
• Adheres to plastics, epoxy, copper, aluminum, ceramics, wood, and most electronic substrates as well as ABS, PLA, and other 3D printing plastics

• Prepare the Surface — Ensure the surface to be drawn on is clean, dry, and smooth. For best adhesion, lightly sand hard surfaces and remove any dirt, grease, or oxidation.
• Shake and Prime — Shake the pen rigorously for at least 30 seconds to thoroughly mix the conductive particles. Depress the pen tip against a test surface until the valve opens and ink flows.
• Apply Conductive Trace — Hold the pen at an angle, press the tip against the surface, and draw the pen across while gently squeezing the middle of the tube to control ink flow for precise lines.
• Allow to Dry — Let the applied trace dry to the touch, which typically takes minutes. For full conductivity and durability, allow at least 10 minutes before returning the device to service.

Typical situations where MG Chemicals 841AR-P Nickel Conductive Pen 5ml (0.17 Fl Oz) | Fast Drying Circuit Repair Pen helps — illustrative scenarios, not customer reviews.