wolovo 45 Degree Cutting Plotter Blades 20mm (0.79in) Length, 1.5mm Diameter, 15-Pack | Precision Tungsten Carbide for Vinyl Cutting

• Precision Tungsten Carbide — Made from high-density tungsten cemented carbide for superior accuracy and an extra-long lifespan, ensuring consistent, burr-free cuts on vinyl and other materials.
• 45-Degree Angle for Detail — The 45-degree bevel angle, identified by the red cap, is optimized for intricate vinyl cutting, allowing for detailed designs and sharp corners with minimal effort.
• Optimized Blade Dimensions — With a 20mm length, 1.5mm diameter, and a 0.25mm knifepoint offset, these blades are engineered for precise depth control and clean material penetration.
• 15-Blade Value Pack — This pack includes 15 blades, providing excellent value and ensuring you have a fresh, sharp blade ready for extended use or frequent project changes.

• Prepare Your Plotter — Ensure your Mimaki cutting plotter is clean and powered on. Refer to your plotter's manual for the correct blade holder installation procedure.
• Install the Blade — Carefully insert the wolovo 45-degree blade into the blade holder. Ensure it is seated correctly and securely. The red cap indicates the 45-degree angle, which should be oriented for optimal cutting.
• Set Cutting Parameters — Adjust your plotter's cutting force, speed, and depth settings according to the vinyl material you are using. Test cut on a scrap piece to ensure a clean, precise result without damaging the cutting mat.
• Begin Cutting — Load your vinyl material into the plotter and initiate the cutting job. Monitor the cutting process to ensure smooth operation. Replace the blade if you notice any degradation in cut quality.

Typical situations where wolovo 45 Degree Cutting Plotter Blades 20mm (0.79in) Length helps — illustrative scenarios, not customer reviews.